The anti-lift jaw system from 5th Axis is available for those customers requiring higher precision and accuracy during secondary operation machining.
The system uses a cleat and angled soft jaw to pull the jaw in and down when torque is applied to the lead screw.
Loosen shoulder bolts and remove the standard master jaws from the vise base.
Take the shoulder bolts and utilize them to bolt the cleats onto the vise base. Torque shoulder bolts to 20 ft lbs. (27.11 Nm)
Take anti-lift soft jaw and insert the soft jaw into the cleat. It helps if you insert the soft jaw at a 45 degree angle. Ensure that soft jaw seats properly into cleat.
Take soft jaw covers and place them on the backside of the jaw. Tighten bolts to secure covers to the soft jaw. These covers ensure that no chips on debris enter the anti-lift soft jaw.
Technical Support Blog
At Next Generation Tool we often run into many of the same technical questions from different customers. This section should answer many of your most common questions.
We set up this special blog for the most commonly asked questions and machinist data tables for your easy reference.
If you've got a question that's not answered here, then just send us a quick note via email or reach one of us on our CONTACTS page here on the website
Our technical section is written by several different people. Sometimes, it's from our team here at Next Generation Tooling & at other times it's by one of the innovative manufacturer's we represent in California and Nevada.
Next Generation Tooling
10240 Cavalletti Drive
Sacramento CA 95829
© 2023 Next Generation Tooling, LLC.
All Rights Reserved
Created by Rapid Production Marketing