During our testing of these parts, the entire production run of these parts was place a container and run through the sPINner for 2 minutes.
The sPINner does not damage even the most delicate parts, so no parts were lost due to bending. Also, the cycle time of 2 minutes for the entire lot was drastically less that the many days it took with manual methods. Lastly, all the parts were fully deburred as the sPINner does not miss areas. All areas of the part are affected equally. This customer has purchased two sPINners to meet a growing production demand.
Visit Earth Chain for more details.
Our blog section is written by several different people. Sometimes, it from our team here at Next Generation Tooling at other times it's by one of the wonderful manufacturer's we represent in California and Nevada